Make sure the surface is completely dry before turning the machinery back on. Hold the can at least 6 to 8 inches from the surface you are spraying and keep the can upright during use.Īllow the product to dry and then wipe it with a lint-free cloth or brush it clean. Test a small area that is inconspicuous before spraying the whole area to make sure the cleaner is compatible with the surface you are cleaning. Turn off all electric equipment or machinery before spraying. Shake the contact cleaner spray can well. Ventilate the area well to avoid breathing in too much of the vapor from the spray can. Our fast-drying electrical contact cleaner. Put on gloves and protective eyewear such as goggles before spraying the product. It provides excellent cleaning with minimal fuss, and removes dirt, dust, condensation and flux residue with ease.
#Contact cleaner how to#
The following steps will show you how to use contact cleaner to clean these various surfaces. Lucas Contact Cleaner aerosol is a unique blend of solvents, cleaning agents and propellants designed to remove oil, dirt and moisture from contact points.
Before connecting to the electrical circuit, wait 10 minutes for the solvent residue to evaporate.Contact cleaner removes dirt, oil, grease, metallic oxides caused by corrosion and moisture from the surface of small pieces of electronic equipment, ignition systems, motors, electronic controls, relays, thermostats and other areas where you need the product to evaporate quickly and leave no residue. In case of contact with the surface of plastic and lacquered parts, remove the composition with a damp cloth. Remove dissolved dirt with a cloth or brush. Spray MANNOL Contact Cleaner on dirt and leave for 5-10 minutes to act, depending on the intensity of the contamination. Can be used for degreasing metal surfaces.īefore cleaning, disconnect the electrical circuit. Silicone-free, safe for plastic and rubber parts, as well as for paint coatings Due to its high penetration capacity, it improves the efficiency and reliability of electronic systems and electrical equipment, preventing failures and failures It is formulated to quickly penetrate into hard-to-reach areas and effectively flush away carbon deposits, dirt, light oils, dust, lint and other light contaminants. The SP10 Contact Cleaner is a contact cleaning spray for electronic, electrical, hospital, health care, sound, computer hardware, heavy mining, marine. They can be solvent based and are used to remove. Provides long-term protection of electrical contacts from oxidation, while maintaining their conductivity CRC CO Contact Cleaner is a plastic-safe general-purpose evaporating cleaner and degreaser for use on sensitive electronic and electrical equipment. Contact Cleaners are used to clean electrical connections, sensitive electronics and areas that are soldered. Quickly evaporates without leaving traces and eliminates current leaks and short circuits
It contains a slow drying, plastics-safe solvent that removes stubborn. Displaces moisture, forms a water-repellent film 801B electrical contact cleaner spray cleans, lubricates and protects contacts. Reduces the electrical resistance of the contacts and thereby reduces the power loss of electrical equipment and stabilizes the voltage Quickly, efficiently and carefully cleans electrical contacts and connectors, as well as electronic elements from fat and oil films, oxides, phosphates, dust and other insulating contaminants. audio and video equipment, office and commercial electrical equipment - cash registers, electronic scales, scanners, etc. plug sockets, clamps, electrical distribution devices, battery contacts in industry and everyday life cleaning of electrical blocks and contacts, electronic circuit boards and terminal blocks, lamp bases, cable lines, communication relays, interrupters, ignition distributors, starters, generators, fuses, etc. Contact Cleaner is a special cleaning agent for fast and effective cleaning and degreasing of dirty and rusted electrical contacts of all types.
0 kommentar(er)
